Software Tips & Tricks

Add This To Del.icio.us Share on Facebook StumbleUpon This Add to Technorati Digg This

Kernel32.dll

The Kernel32.dll file handles memory management, input/output operations, and interrupts. When you start Windows, Kernel32.dll is loaded into a protected memory space so that other programs do not take over that memory space.

On occasion, you may receive an invalid page fault (IPF) error message. This error message occurs when a program tries to access the Kernel32.dll protected memory space. Occasionally, the error message is caused by one particular program, and other times the error message is provoked by multiple files and programs.

If the problem results from running one program, the program needs to be replaced. If the problem occurs when you access multiple files and programs, the damage is likely caused by damaged hardware.

You may want to clean boot the computer to help you identify the particular third-party memory-resident software. Note that programs that are not memory-resident can also cause IPF error messages.

The following conditions can cause Kernel32.dll error messages:

• Damaged swap file
• File allocation damage
• Damaged password list
• Damaged or incorrect version of the Kernel32.dll file
• Damaged registry
• Hardware, hot CPU, over clocking, broken power supply, RF noise, ground bounce, or bad hard disk controller
• BIOS settings for Wait states, RAM timing, or other BIOS settings
• Third-party software that is damaged or incorrectly installed
• .dll files that are saved to the desktop
• Non-existent or broken Temp folder
• A control panel (.cpl) file is damaged
• Incorrect or damaged hardware driver
• Incorrectly installed printer drivers or HP Jetadmin drivers
• Damaged Java Machine
• Damaged .log files
• Damaged entries in the History folder
• Incompatible or damaged dynamic link library files
• Viruses
• Damaged or incorrect Msinfo32.exe file
• Low disk space

More on the possible causes:

• Bad memory modules:

You can test your memory modules by inserting the command: DEVICE=C:\WINDOWS\HIMEM.SYS /TESTMEM:ON into your Config.sys file. You can use the System Configuration Utility:

1. Select Start>> Run and type: msconfig [Enter]

2. Next, select the Config.sys tab and add the HIMEM.SYS line (above) by pressing the New button.

3. Windows will tell you to reboot your computer.

4. Watch your screen for a message; "HIMEM has detected unreliable memory at address xx:xxxxxx" which will certainly indicate that there's a memory problem.

Note: Memory problems may not immediately surface from the result of this test. It may take many reboots or even a few days for the above message to appear.

• CPU, bus speed or multiplier overclocking.

• Graphic acceleration set too high:

Select Control Panel > System, then select the Performance tab, click the Graphics button. Turn down Hardware acceleration by moving the slider a notch to the left, reboot, try again.

• Bad or outdated drivers, especially video drivers:

Check with your card manufacturer for an updated set of drivers. Video drivers are updated constantly, it pays to have the latest release, especially if you find yourself having problems with Internet Explorer.

For Further Reading,

Tips